This article applies to Linux users in all licenses.
TeamViewer (Classic) for Linux requires at least Linux 2.6.27 kernel and GLIBC 2.17. The following minimum operating system versions are supported:
- Debian 10 (incl. Raspbian)
- Ubuntu 20.04 and derivates (e.g. Kubuntu)
- Mint 20
- RHEL 7, CentOS 7, Fedora 33
- SUSE Enterprise 15, openSUSE 15
📌 Note: As of TeamViewer 15.19 Qt is not required to be installed. Below TeamViewer 15.19 Qt 5.6 is recommended for the best experience.
x86 64 bit: amd64 (Intel 64/EM64T)
x86 32 bit: SSE2
armv7 32 bit: armv7 hardfloat (Raspberry Pi 2+)
Choose your package
For PC: Choose the 64- or 32-bit package according to your system
- If in doubt, run
- On a 64-bit system,
uname -m will print
For Raspberry Pi: Choose the ARM package
Installing TeamViewer (Classic)
The package can usually be installed by double-clicking or right-clicking on the icon and selecting the package manager (e.g. Open with software installation, Open with GDebi package installer, Open with Ubuntu Software Center, or Open with QApt package installer)
If you prefer the command line, run
# for DEB packages:
apt install ./teamviewer_15.x.yyy_[arch].deb
apt install ./teamviewer-host_15.x.yyy_[arch].deb
# for RPM packages (use dnf if yum is not available):
yum install ./teamviewer_15.x.yyy.[arch].rpm
yum install ./teamviewer-host_15.x.yyy.[arch].rpm
# for SUSE:
zypper install ./teamviewer-suse_15.x.yyy.[arch].rpm
zypper install ./teamviewer-host-suse_15.x.yyy.[arch].rpm
- To install on RPM systems (including Fedora), if signature verification fails, for general installation instructions on RHEL or CentOS, see the following article:
- To install via ssh or configure unattended access on the command line, see the following article:
teamviewer-hostcannot be installed side by side. If you want to install teamviewer-host, teamviewer must be removed first. If you want to run teamviewer occasionaly, you can use the tar package and run it without installation.
- Updates are available from our repository.
- To run TeamViewer without installation, please take a look at the following: TAR package.