-
Starter kit
This section describes the TeamViewer IoT Starter Kit and its components in detail. The TeamViewer IoT Starter Kit is a preconfigured edge device purchasable from TeamViewer. See the articles below: Safety Technical Data Set up the Starter Kit Disposal
-
Safety
The following guidelines help ensure your safety and protect the device from damage. The list of guidelines might not address all potentially hazardous situations in your working environment, so be alert and exercise good judgment at all times. Perform only the procedures explicitly described in the documentation for this…
-
Set up the starter kit
Before you begin any of the procedures in this section heed the information in the section Safety. What you will Make sure that you have prepared the following points: Your TeamViewer credentials. You received them per E-Mail upon ordering the Starter Kit. The TeamViewer Client is installed.…
-
Enable GPS receiver on the starter kit
The TeamViewer IoT Starter Kit contains a built-in GPS receiver. What you will need Make sure that you have prepared the following points: Your TeamViewer credentials. Make sure that the WiFi antenna is connected to the edge device (see Setup the Starter Kit). The edge device is set up with a TeamViewer IoT Agent…
-
Enable mobile internet connectivity with SIM Card on the Starter Kit
The edge device of the TeamViewer IoT Starter Kit has a built-in modem (4G). What you will need Make sure that you have prepared the following points: Make sure that the Wi-Fi antenna is connected to the edge device (see Set up the Starter Kit). An unlocked SIM card to connect to mobile internet. The Access Point Name…
-
Reassign the Starter Kit to another TeamViewer Account
Use this procedure to move the TeamViewer Starter Kit from the preassigned account to another TeamViewer Account. This procedure contains 3 basic steps: Unmanage and Reassign the Starter Kit Reconfigure the Digital Inputs/Outputs Apply the Reconfiguration and Restart What you will need Make sure that you have prepared the…
-
Disposal
In August of 2005, the European Union (EU) implemented the EU WEEE Directive 2002/96/EC and later the WEEE Recast Directive 2012/19/EU requiring Producers of electronic and electrical equipment (EEE) to manage and finance the collection, reuse, recycling and to appropriately treat WEEE that the Producer places on the EU…
-
Technical data
This section describes all technical data of the following products contained in the TeamViewer IoT Starter Kit: Power over Ethernet Wall Plug Adapter (POE) Dell Edge Gateway Bosch Sensor XDK110
-
Power over ethernet wall plug adapter
The Power over Ethernet Wall Plug Adapter (POE) is used to connect the Edge Gateway with a power supply (e.g. wall socket). See Attached Files to download the full documentation. Safety approvals cUL / UL CE SAA C-Tick Diagram units in mm (inch) Dimensions and weight Length: 80mm (3.15in) Width: 45mm (1.77in) Height: 33mm…
-
Dell Edge Gateway
The Dell Edge Gateway 3001 is the preconfigured edge device of your TeamViewer IoT Starter Kit. It enables you to collect, secure, analyze, and act on data from multiple devices and sensors. See Attached Files to download the full documentation. Safety Approvals CE complies with FCC radiation exposure limits complies with…
