-
Quickstart for TeamViewer Embedded Starter Kit
In this quickstart, you will learn how to set up your TeamViewer Embedded Starter Kit and run it quickly. Before you begin any of the procedures in this section heed the information in the section Safety. Your Starter Kit contains the following items: 1x Dell 3001 edge gateway with PoE power supply (PoE = Power over…
-
What you will need to set up a TeamViewer Embedded Starter Kit
Make sure that you have prepared the following points: Your TeamViewer credentials. You received them per E-Mail upon ordering the Starter Kit. The TeamViewer Client is installed. Visit https://www.teamviewer.com/ to download the application. A working local network with a router. Multiple USB power supplies – one for each…
-
Set up the Starter Kit
Set up the Dell 3001 edge gateway (A) and ensure it is connected to an internet router: Mount the Wi-Fi antenna (B) to the right side of the gateway (A). Connect your router with one Ethernet cable (C). Connect that Ethernet cable with the IN female connector of the included PoE power supply (D). Connect the OUT connector…
-
Connect the sensors to the Starter Kit
Choose a proper location for your Bosch XDK110 sensors (E). 📌Note: Minimize disturbing effects on your measurements, e.g. avoid exposing your sensor to sunlight when measuring temperature or brightness. Connect each sensor with a USB cable (F) and plug them into USB power supplies (not included). Switch the sensors ON (E).…
-
Use the Embedded Management Console to Check the Setup
Once your device is up and running you can log in to the Embedded Management Console. The Embedded Management Console lists all your devices, connected sensors, and much more information. To log in to the Embedded Management Console, open https://teamviewer-iot.com and use your TeamViewer account credentials. From the left…