Port and IP Setup for wake on lan?
Hello,
Im trying to setup my TV14 so I can start my PC from my phone. Everything is setup correctly according to the manual, but I can not figure out which IP and port information to put where?
What do i put here:
Is it correct the Incoming Lan con. is set to deactivated?
How should I forward these ports?
Unfortunetly I do not have a lot of knowledge about this, I just need it to work
Hopefully someone can help.
CHeers
Comments
-
Hi @oxigine
Thank you for your post.
Did you read the following article carefully? - How does Wake-on-LAN (WOL) with TeamViewer work?
The Wake-on-LAN manual is also a helpful guideline to set up WOL.
If there are any further questions, please do not hesitate to contact us again.
Wish you a great start into the new week.
All the best,
NataschaGerman Community moderator 💙 Moderatorin der deutschsprachigen Community
0 -
Yes I have, and that documentation in unfortunately not telling me what to put where.. There is an IP that goes somewhere?
Where can I find these numbers?
0