Authentication rejected on one computer in my group
I have been connected with no problem for years, but now there was a connection problem with one of the computers in my group.
So I uninstalled with removing settings and reinstalled Teamviewer.
However, now it says that Authentication rejected.
Is there any way to removing all prior Authentication on that computer completely to install fresh?
Best Answer
-
Check/Re-enter the Properties in the Computer & Contacts screen for the correct password. The only time I have seen the message you are getting is when I try the wrong password more than three times. You can get to the Screen I am talking about by clicking the Down Aarow shown by a Yellow Aarow pointing at it then properties.
On principal I also recomend making sure that all of your Clients and Hosts are running the same, most up to date ideally, version of TeamViewer
If my post was helpful, Please throw me a Kudos.
If my post fixed your issue, please mark it as the solution to help the next person find a solution quickly.
Bart Lanzillotti6
Answers
-
Check/Re-enter the Properties in the Computer & Contacts screen for the correct password. The only time I have seen the message you are getting is when I try the wrong password more than three times. You can get to the Screen I am talking about by clicking the Down Aarow shown by a Yellow Aarow pointing at it then properties.
On principal I also recomend making sure that all of your Clients and Hosts are running the same, most up to date ideally, version of TeamViewer
If my post was helpful, Please throw me a Kudos.
If my post fixed your issue, please mark it as the solution to help the next person find a solution quickly.
Bart Lanzillotti6
