Auto accept dialog box after installation

Hey!
I have a question about Teamviwer installation. We use SCCM to deploy Teamviwer. Everything works as it should. Teamviwer registers as it should with our ID. But after installation, a box will appear. Can I remove the dialog box? Is there anything in the registry value that can be changed so that this box does not appear? Because we want to get a quiet installation where users do not have to do anything. I attach a file with the box I wish to remove.

Sincerely
John Rosell

Find more posts tagged with

Comments

johros

Hey!
Thanks for the reply. But it does not describe my problem. I have no problem deploying TeamViewer via SCCM. It works fine. I use this string for installation on the client: "msiexec /i TeamViewer_Host-idcxxxxxxx.msi ALLUSERS=1 /QN" (were xxxxxxx is our company ID). It works. But after the installation has finished, there will be a box that the user must accept. This will be a problem on some users. I will add the dialogbox again as I wish to get away. There should be some registry value you can change or something else. That's what I want years of help with. I have looked at youre community and searched the Internet. But I have not been able to find anything about this. I automatically want "Allow and Finish" without the user having to press the button.

SINCERELY
John Rosell

christian-j

Hello johros,

have you already seen our knowledge base article "Mass deployment improvements"?

It is not SCCM specific, but you should be able to use same mechanisms for it.