Highlighted
Posted by
Photon

Stuck in Intitialiazing Parameters Display

Hello,

I was using team viewer 15.4 to remote contol a pc which I don 't have physical access because it is in another city. During last session that pc RAM-overflowed and that had as a result to terminate that session and since then everytime I am trying to reconnect, teamviewer stucks at initializing parameters display. When I connect through file transfer mode everything works normally. Is there any way to reboot that pc remotelly?

Thank you

1 Reply
1 Reply
Highlighted
Posted by Moderator Moderator
Moderator

Re: Stuck in Intitialiazing Parameters Display

Hello @NikNom,

Thank you for your message and welcome in the Community! 🙌

As we published a new version (v15.5.3), could you please update TeamViewer on both sides and check if it works again?

You will find all the information you need about how to update in our Knowledge Base article here: How do I update TeamViewer? 

Best,

Jean

French Community Moderator

If my reply answered your question, help out other users and click the Accept as a Solution button below. ✅
You can also say thanks by clicking on the Thumbs Up button!
Thanks for being an active member of our Community!